Pottery provides design, strength and durability to a wall. Put a detail in the corner of the fire, an ending to the ground or sky space, or cover an entire wall. Careful preparation and installation ensures the enjoyment of tiles in your living room for years. A possible removal of a work piece can damage the tiles for living room walls, so that considered a tiles coating applied to a wall is a continuous treatment for the same and represents, therefore, careful consideration.
Before installing tiles wall, testing the strength of the same pressing with the palm of your hand. If you find weaknesses, apply nails or screws to secure to the wall studs. Plaster walls can be torn down and replaced with drywall or plaster can be applied over existing plaster. Because the application of gypsum plaster on the wall thickens, you may have to adjust or trim moldings. Check the wall with a carpenter’s level on several points. Apply drywall compound in the small valleys and sand to level. The larger imperfections can be arranged by placing shims behind the studs. If you find a hole in the drywall, use a saw to cut a few inches larger than the whole square to transform its irregularity in a box, it is easier to repair. Use a drywall patch kit to fill the hole, let it dry and sand lightly. Remove loose paint and sand the entire wall until it is smooth. Remove the moldings and wall decorations, cut electricity, remove switch plates and trim and wallpaper strips placed along any particular pothole. Fixed drywall on masonry or brick walls. Place a horizontal strip of wood as a bar on the ground or in the lower horizontal edge of the tile, then novella using a carpenter’s level with reference to the same bar and not the floor or ceiling. Because floors and walls settle over time, as the floor and ceiling may not be exactly horizontal bar level to make an accurate start putting the pieces so you will not see diagonal lines together to Horizontal always in tiles for living room walls.
If the wall contains a large obstacle, starts putting the pieces around the obstacle first and then continues to work out, so you avoid placing small cuts just a focal point of decoration. For example, put the first piece in the center, just below a window and works from that point right and left, up and down, to complete both sides and then continue working on the rest of the wall. Draw on paper or computer design before installing the parts and use a pencil to mark the decorative details you want to put on the wall. Use a trowel and putty for the living room walls instead of thinnest you would use in a bathroom or kitchen because these walls are normally dry. Plastic cement keeps the moving part about 30 minutes, making it easy placement, but the adhesive mortar supports better moisture. Press each piece into putty using spacers to achieve the desired joint between pieces. Tapping each with a rubber mallet to seat firmly into the putty and then clean any excess adhesive with a damp cloth. Finally, let the putty harden thoroughly before applying the joint according to the manufacturer’s instructions.Most of you find this article from search engine used keyword bellow : tiled walls in living room,